2-4
2
MOUNTING
2.1
PERFORMING INSTALLATION
Installation of this product should be performed by an appropriately licensed Electrician. The
device should be mounted away from sources of excessive heat or electrical interference and
be placed at a location central to all WX sensor nodes. Installation with line of sight to sensor
nodes is ideal, also installation at high elevation is preferred.
Installation and wiring methods should comply with all applicable Electrical codes.
2.2
MOUNTING
–
STEP ONE (1)
Fix the bracket included in the mounting kit on the bottom of the enclosure with four M6*12
screws.
2.3
MOUNTING
–
STEP TWO (2)
Position and tighten the pole clamps together around the pole with bolts, washers, and nuts.
The diameter of the pole that is supported by the brackets is 50-100 mm. If the pole diameter is
more than this value, hose clamps can be used. The standard mounting kit does not include
hose clamps. If needed, they should be purchased separately. The clamp's back also has
openings for hose clamps that are not included in the mounting kit. Position the enclosure and
fasten it with two M6*12 screws.
