3.6. Charge batteries timely. It’s required to control the state of charge by looking at
the battery charge level in the top line of the display, the color of it and the degree of filling.
3.7. The correct way to charge batteries:
- connect the proper cable connector supplied to the charger supplied. Connect another
cable connector to the charging cavity (no. 6 fig. 2). While charging, if the device is working the
pictograph informing of the chosen power type takes the form of
. If the device is switched
off there is the static picture on the screen while charging (Fig. 13).
Figure 13 – Charging when switched off
4. Failure table
The Table 3 contains the troubleshooting information.
FAILURE
CAUSE
REMEDY
The Radiation meter is turned on
but there is no picture on the screen
Batteries
are
fully
discharged
Renew
or
charge
the
batteries
Device is damaged
Repair should be carried out
by the dealer
5. Package and transportation
Every Product delivery set (see Table 2) is packaged in individual corrugated fiberboard
box. The moving of contents of the box is not allowed. The packaged products are put into
cargo corrugated containers according to the GOST 22637.
Packaged products can be transported by train or by trucks in covered trucks or containers
or by air transport in pressurized modules.
While transporting the packaged products should be protected from the direct impact of
atmospheric condensation and insolation.
Transportation terms and conditions:
−
environment temperature: from -50 to 50
С;
−
relative humidity: below 95 % at temperature 25
С;
−
atmospheric pressure: from 84 to 107 kPa (from 630 to 800 millimeters of
mercury);
−
shock acceleration peak values below 147 m/s2 (15 g), with shock acceleration
duration 10-15 ms.
While shipping and transporting the requirements of the package warning labels should be
performed rigorously.
6. Proof of acceptance
Radiation meter EcoLife Pro1
TC 4362-007-64062607-2015
