pressing the button
and holing it pressed (at least for 3 sec);
- decrease the level of sensitivity by pressing the
button repeatedly, and automatically adjust the
sensitivity to the ambient electromagnetic field by pressing the button
and holing it pressed (at least for 3
sec).
3.3 To switch between modes press
in turn, notice that:
a) if the indicator
flashes permanently, the Product is in analog “bug” search mode (permanent signal);
b) if the indicator
flashes on and off rapidly, the Product is in digital “bug” search mode (impulse
signal);
c) if the indicators
flash on for a short term and off next, the Product is in security mode (the
Product indicates if a new signal source has been detected in the room). This mode provides optimal sensitivity
and effective battery charge economy.
To switch the Product into the modes with additional sound indication press the button
and hold it
pressed at least for 3 seconds, notice that:
а) if the indicator
flashes on and off, the Product is in the mode with signal level sound indication
(frequency and periodicity of sound ‘beeps’ depend on the signal level);
б) if the indicator
flashes permanently, the Product is in ‘sound feedback’ mode (a RF bug can be
detected within 0,5 meters field);
в) if the indicator
doesn’t flash, the sound indication is off.
If the Product is switched off, briefly press the
button, and the battery charge level will be displayed
on the indicating scale for a short time:
- the whole indicating scale is displayed – the battery charge level is 100%;
- no LEDs lights– the battery is almost completely discharged;
- 1 LED - 10% of maximum battery charge level, 2 LEDs - 20% of maximum battery charge level, etc.
4. Оperation procedure
4.1 To switch the Product on press the button
, and next and press the button
and keep it
pressed for 3 seconds at least. After switching on the sensitivity of the Product will be adjusted to the ambient
electromagnetic field automatically.
4.2 Begin to walk around a room, holding the device at the distance of 0,3 – 0,5 meters from the researched
surface. If a maximum signal strength level is displayed on the indicating scale (all LEDS on the indicating scale
are on), press the button
and keep it pressed for 3 seconds at least. Repeat these actions until the site, where
the evident maximum level of emission is, is located.
