In order to charge the battery you need to insert the charger plug into the jack (item 4) and move the power
switch (item 1) to ON position. Then the red LED starts flashing and the charging process begins. The battery is
fully charged after the red LED turns off, the device is ready for use.
NOTE:
When the battery is almost dead, the red LED starts to flash in 1 ... 3 minutes after the device is put on
charge. During the charging process,
do not use
the device.
2.2.4 The device does not requires any special skills and it is easy to use. It allows you to detect a camera lens
at 18 meters distance. Detection range depends room’s illumination.
2.2.5 In order to turn off the device, move the power switch (item 1) to OFF position.
2.3. Spy cameras search recommendations
The basic rule to detect spy cameras is that the search should be performed in a place where people could
probably place a spy camera. The most likely places for camera installation are those from where the working spaces,
resting places (chairs, sofas, etc.) and doorways can be easily observed. The camera can be installed in a hollow
space of a suspended ceiling, in premise’s corners, ventilation shaft, furniture elements (wardrobe, mezzanine, etc.),
comfort items or audio-video equipment, etc.
You must consider that
there may be several cameras. Detection of one or two video cameras do not allow you to
consider that the room is completely cleared. To be completely sure of your safety, it is necessary to check all the
places from where a latent recording can be performed.
To determine what flare you see - spy camera lens or simply a reflection on a smooth surface (e.g., glass or
mirror) – you can move aside slightly and continue to observe the same area with the working device. In this case a
simple flare disappears, shifts or significantly changes its intensity. However, the bright point of the camera lens
remains in the same place and there is a slight change in flare intensity until you stay in a sweep of a camera.
Still you need to remember about the optimal working distance which is not more than 18 meters and that the
camera can be detected only being in its sweep. Consequently, for more certainty it is recommended to observe the
most suspicious places from different angles.
3 MAINTENANCE
3.1 Maintenance requires only charging of the battery as well as cleaning the surface of the device.
3.2 Current repair. Troubleshooting
Typical problems and possible solutions are specified in Table 2.
Table 2
Problem
Possible reasons
Possible solution
Device is not turning ON
Battery is dead
To charge the battery
Device is defective
Take the device to service center
