Installation
B)
Powering Off the Projector
1.
Press the ” button on the remote control or on the control panel to turn off the projector.
The following message will be displayed on the screen.
Press the ” button again to confirm otherwise the message will disappear after 10 seconds. When
you press the ” button for the second time, the fan will start cooling the system and will shut down.
2.
The cooling fans continue to operate for about 4 seconds for cooling cycle and the POWER/STANDBY
LED will flash Orange. When the POWER/STANDBY LED lights solid Orange, the projector has entered
standby mode.
If you wish to turn the projector back on, you must wait until the projector has completed the cooling
cycle and has entered standby mode. Once in standby mode, simply press ” button to restart the
projector.
3.
Disconnect the power cord from the electrical outlet and the projector.
C)
Warning Indicator
When the warning indicators (see below) come on, the projector will automatically shut down:
•
“LAMP” LED indicator is lit red and if “POWER/STANDBY” indicator flashes amber.
•
“TEMP” LED indicator is lit red, this indicates the projector has overheated. Under normal
conditions, the projector can be switched back on.
•
“TEMP” LED indicator flashes red and if “POWER/ STANDBY” indicator flashes amber.
Unplug the power cord from the projector, wait for 30 seconds and try again. If the warning indicator
lights up again, please contact your nearest service center for assistance.
Note:
•
Contact the nearest service center if the projector displays these symptoms.
