4
4. V-phase Adjustment
: When using two cameras or more, the image on the
monitor may roll vertically when switching sources. This rolling can be
minimized by adjusting this controller.
5. DC IRIS Level Adjustment
: Use to compensate for the Iris Level of a
DC-type auto-iris lens. Turn counterclockwise towards L (low)/ clockwise
towards H (high) to make the picture appear darker/brighter.
6. Back-Focus Adjustment:
6A. Back Focus Screw:
Loosen the back focus screw before using focus
adjustment. Tighten after the desired focus is achieved to maintain setting.
6B. Focus Adjustment:
Adjust focus adjustment dial to obtain correct back-
focus (applies to CS mount lenses).
7. DIP Switch:
Function adjustment. (For further instructions see pp.4-6)
8. Video Output Terminal (BNC):
Connect external (“spot”) monitor to assist
adjustment of camera during installation.
9. Forced to BW external control terminal:
The camera will be forced to BW
mode with external contact.
NOTES OF USE
Dip Switch Panel
Side panel of the camera contains the Dip Switch panel with 12 dip switches.
Function of each dip switch is shown in the table below.
Dip Switch Name
Dip Switch Function
N-AGC / S-AGC
Auto gain control (normal AGC= 24 dB / super AGC = 30
dB)
BLC OFF / ON
Back light compensation (On / Off)
L-LOCK / INT
Sync system (Line-lock / Internal)
SOFT / SHARP
Picture sharpness (Soft / Sharp)
ATW1 / ATW2
Auto white balance (ATW1 / ATW2)
CL / AUTO
ICR mechanism (Colour / Auto)
AES / AI
Exposure control (On / Off)
IR-OFF / IR-ON
IR lamp (On / Off)
MES
Manual shutter ranged from 1/50 (1/60) to 1/100k
