nano
LAP
Connect the serial cable to the PC. Insert the
communication jack into nanoLAP. Turn on
nanoLAP.
Data will be automatically downloaded to the PC.
Here we show a typical download:
Produced by I2M
Mini Trasponder Ir
www.i2m.it
Identificativo :
Tempo morto (s): 2
Sessioni: ON
Autospegnimento: OFF
Giri memorizzati: 9
Best Lap: 0:56,41
Lap 1: 1:00,49
Lap 2: 1:00,39
Lap 3: 1:03,05
Lap 4: 1:00,34
Lap 5: 0:56,90
Lap 6: 0:56,76
Lap 7: 0:56,41
Lap 8: 0:59,53
Lap 9: 0:56,31
Premere
'A' per l'autospegnimento
'C' per cancellare la memoria
'I' per modificare l'identificativo
'S' per le sessioni
'T' seguito dal valore (Sec.) per il tempo morto
After the download ends, it is possible to configure
the system.
By pressing ‘A’, “
Autospegnimento
“ (
auto power
off
) can be turned on or off (if on, nanoLAP will
power itself off after 10 minutes if it does not
receive any valid signal).
Pressing ‘I’ let you modify the “
Identificativo
”
(
identifier)
(the “name” of your nanoLAP). NB: the
identifier can be at most 8 characters.
Pressing ‘C’ will “
Cancellare la memoria
” (
clear
the memory)
.
The memory can also be cleared without
connecting nanoLAP to a PC: when turning on
nanoLAP, keep the button pressed, the indicator
will flash for a few seconds and then turn off.
When the indicator will turn on again, clear will be
completed.
By pressing ‘T’ you can set the “
Tempo morto
”
(
dead time
).
Pressing ‘S’ enables or disables “
Sessioni
”
(
sessions
). When sessions are enabled, data will
be downloaded divided by session, and each
session is closed when nanoLAP is turned off.
Moreover, each session takes up additional space
in memory, corresponding to a single lap. Thus
the maximum number of laps will be smaller:
100 – number of sessions.
If the memory content is large enough to exceed
HyperTerminal window size, the visualization may
be poor. In such case we advise to use the option
Capture Text (Transfer -> Capture Text…): data
will be saved in a text file to be reviewed later in a
text editor. At the end of the download, close the
file by choosing Transfer -> Capture Text -> Stop.
We advise against the use of Notepad, since it
does not handle correctly formatted text, and data
will be difficult to review.
To download the same data again, press the
button near the jack connector.
At the end of the download and configuration,
disconnect the cable from nanoLAP. nanoLAP
will automatically power off.
When the memory if full, the indicator will signal
“
memory full
” by flashing rapidly (3 times per
second).
nanoLAP absorbs 3 mA, so a new battery will last
for about 60 hours.
