I-VALO VIVO 9309, Руководство по установке

Страница: 13 / 20

13
I-VALO OY | TEL +358 (0) 10 501 3000 | INFO@I-VALO.COM | WWW.I-VALO.COM
EN
LAMP REPLACEMENT
•
Any defective bulb must immediately be replaced with a new one.
•
Verify the appropriate bulb type from the luminaire’s rating label. The bulb type stated in the label and
the connecting device must match each other.
•
Familiarize yourself with the user guide that comes with the lamp.
•
Follow the lamp manufacturer’s instructions for burning hours and economical service lifetime. “Group
relamping” of luminaries is recommended.
•
Any luminaire that does not have a bulb inside must be disconnected from the power outlet!
•
VIVO LED: The light source may be replaced only by the manufacturer or a person authorised by
the manufacturer. The product contains electronics sensitive to electrostatic discharge (ESD) and
mechanical stress. In order to avoid damage to the LED chips, avoid touching an uncovered circuit board,
such as the LED module, by hand or with a tool. This must be taken into account during maintenance.
•
The luminous emittance of LED luminaires has a tolerance of ±10%. The luminous flux of LED light sources
decreases over their service life just like that of traditional light sources. When an old LED luminaire is
replaced with a new one, the difference in luminous emittance may be evident to the naked eye due
to the better lighting power of the new luminaire. The colour temperature of the luminaire may also
change.
CHANGING ELECTRICAL COMPONENTS
•
If a luminaire component breaks for any reason, it must immediately be replaced with a similar
component.
•
The rating plate indicates the electrical values and appropriate light source for the luminaire.
•
Remember to check the condition of the electrical components and wiring in conjunction with every bulb
replacement; at the same time, you should also replace any other wearing parts of the luminaire.
•
The indicative service life of the components is as follows:
- control gear 50.000 hrs
- LED module 100.000 hrs
•
Do not change electrical connections or the location of the components!