Apr 05
P.17
D.
Setup Touchscreen
For DOS (Cont.)
7. Type INSTALL followed by the source disk drive, the destination drive, and
the destination directory.
For example, the following command copies the files from Drive A (source
drive) to Drive C (destination drive) and the \MTS\TOUCH directory :
INSTALL A: C:\MTS\TOUCH
8. Press Enter. The system reports that it is about to copy the DOS touchscreen
files and prompt for confirmation that you want to continue.
9. Press
C
to start the installation.
●
First, the Install program copies all DOS touchscreen files from the
TouchWare diskette to the specified destination drive and directory.
●
Next, the Install program automatically searched through the system
and configures the touchscreen to the proper COM port, interrupt, and
communication rate.
●
Finally, the Install program prompts if you want it to automatically modify
your AUTOEXEC.BAT file
If you let the Install program modify your AUTOEXEC.BAT file, the system
automatically loads the DOS touchscreen driver whenever you start your
computer.
If you do not let the Install program modify your AUTOEXEC.BAT file, you
must load the DOS touchscreen driver before using a DOS touch application.
For more information, refer to
“
Loading the DOS Touchscreen Driver
”
in the
next page
4. Using the System
HAP-19AV / HDP-19AV / HOP-19AV Series
Содержание HAP-19AV Series
Страница 4: ...Apr 05 P 3 HAP 19AV series C Dimension Diagrams 2 Introduction HAP 19AV HDP 19AV HOP 19AV Series...
Страница 5: ...Apr 05 P 4 HDP 19AV series C Dimension Diagrams 2 Introduction HAP 19AV HDP 19AV HOP 19AV Series...
Страница 6: ...Apr 05 P 5 HOP 19AV series C Dimension Diagrams 2 Introduction HAP 19AV HDP 19AV HOP 19AV Series...
