i.safe MOBILE MTHA10, Быстрый старт: Инструкции по безопасности

Страница: 5 / 76

EN 5
NAME CONCEPT
The two “xx” in IS-TH1xx.M1 are placeholders. The IS-TH1xx.M1 comes in two variants with
different scan ranges and scan engines:
name (model) scan range scan engine
IS-TH1MR.M1 (MTHA10) mid range Zebra SE4750 (MR)
IS-TH1ER.M1 (MTHA11) extended range Zebra SE4850 (ER)
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it must
be withdrawn from use and removed from any ex-hazardous areas immediately.
Measures must be taken to prevent any accidental restarting of the device. The safety of the
device may be compromised, if, for example:
Malfunctions occur.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been stored improperly.
Markings or labels on the device are illegible.
We recommend that a device displaying errors or in which an error is suspected be sent back
to i.safe MOBILE GmbH to be checked.
EX-RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety regulations and
has read and understood manual, safety instructions and certificate.
When used in ex-hazardous areas, the following safety regulations must also be complied
with:
The device may be connected only outside ex-hazardous areas to the IS530.M1 via the ISM
interface.
To ensure the IP-protection, it has to be ensured that all gaskets are present and functional.
There must be no large gap between the halves of housing.
The device must be securely fastened to the ISM interface when used in ex-hazardous areas.
The device may not be exposed to any aggressive acids or alkalis.
The device shall be protected from the exposure of oils, greases and hydraulic fluids.
The device may only be used in zone 1, 21, 2, 22, M1 and M2.
The device must be protected from impacts with high impact energy, against excessive
UV light emission and high electrostatic processes.
Only accessories approved by i.safe MOBILE GmbH may be used.