I.S.V.E. Tritotutto 50, Инструкция по эксплуатации и обслуживанию

Страница: 36 / 57

6 - FUNCTIONING 6-1
I
6 - 3
6.2 PROGRAMMING MACHINE PARAMETERS WITH MINIDISP01-VI BOARD
OPERATOR PANEL
TERMINOLOGY:
Internal board:
this is the main electronic board which manages the machine. It is placed in the
main switchboard.
External board or keyboard: this is the board that enables the user to programme the machine
and to check functioning.
It is placed in the electrical control panel.
Display: it is part of the external board and displays the messages for managing the machine.
PROGRAMMING:
The operator has 10 work programmers at his disposal (keys 0-9).
To programme follow the steps below:

With the machine powered but not operating, press the key with dotted line.

The message
“
choose function
”
will appear on the display, press key 1
 “
ENTER PASSWORD
”
will appear on the display, press key 2, then key 0, then key 7, then
the ENTER key
 “
WHICH PROGRAMME
”
will appear on the display, press the key corresponding to the
programme you want to save (e.g. key 1);
WARNING: do not change programmes 1 and 2 set by the company.
 “
Total cycle time
”
will appear on the display:
Description : indicates the total operating time of the machine prior to automatic switch-off.
Programming: write in the time, in minutes, using the numerical key, confirm by pressing
“
enter
”
(note: an 0 setting means it will always remain on)
 “
Time shredder ON
”
will appear on the display:
Description:
should the pause/work function of the shredder be envisaged, this parameter
indicates the operating time of the crusher;
Programming:
insert the time you wish the shredder to remain on (an 0 setting means it will
always remain on), using the numerical key, confirm by pressing
“
enter
”
 “
Time shredder OFF
”
will appear on the display:
Description: should the pause function of the shredder be envisaged, this parameter indicates
the pause time of the machine.
Programming: insert the time you wish the shredder to remain off, using the numerical key,
confirm by pressing
“
enter
”
Note : this operating system can be useful to automatically regulate the load flow of the
mill group (programme 2) or to facilitate gripping difficult material.
“
Number inversions
”
will appear on the display:
Description : indicates the number of inversions the machine must carry out within a set period
of time before the unit goes into the alarm mode. This can be useful in avoiding damage to the
machine due to accidental introduction into the hopper of ferrous or non shredable materials.
SHREDDER
(updating of version 1.18 visible on starting the machine)