12
■
Indicators and buttons
C
ACT indicator
B
LINK indicator
D
SD MOUNT indicator
A
INITIAL SET button
G
TELE button
H
WIDE button
F
SD ON/OFF button
E
SD memory card
warning/error indicator
A
INITIAL SET button (Initializing / NTSC PAL switch button)
Follow the steps below to initialize the network camera.
(1) Turn off the power of the camera. When using a PoE hub, disconnect the Ethernet cable
from the camera.
When using an external power supply, disconnect the 2P power cable (WV-QCA501A
accessory) from the power supply cable (12V DC).
(2) Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds. In about 2 minutes later, the camera will
start up and the settings including the network settings will be initialized. Retry if the camera
does not start up normally.
IMPORTANT:
• When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
• Do not turn off the power of the camera during the process of initialization. Otherwise, it
may fail to initialize and may cause malfunction.
• When the INITIAL SET button is pressed (less than 1 second) to switch the output signal of the
MONITOR OUT terminal, the MONITOR OUT terminal can be switched for the NTSC monitor
PAL monitor.
B
LINK indicator
• When the camera is able to communicate with
Lights orange
the connected device
C
ACT indicator
• When data is being sent via the network camera
Blinks green (accessing)
