1.7 Precautions for Installation
Install the unit in accordance with electrical equipment technical standards.
Before beginning to install and connect the unit, check and prepare all necessary
peripheral equipment and cables. Turn off the power supply of the unit, camera, and
other components before connecting them.
All electrical wiring should be performed by a qualified electrician.
Consult an authorized dealer for installation.
Power supply
This product has no power switch. When turning off the power, disconnect the power
supply from the AC adapter (accessory) and the PoE device. Install the unit so that the
AC cord or LAN cable can be easily disconnected.
1. The unit is intended for indoor use only
•
The unit cannot be used outdoors. Do not install the unit in areas that are exposed
to direct sunlight for long periods of time, or areas near heaters or air conditioners.
Installing the unit in such areas may cause malfunctions and cause the unit to
change shape or color. Do not use the unit when they have been exposed to
water or moisture.
2. Do not install or use the unit near medical equipment
•
High-frequency signals emitted from the unit may affect the operation of medical
equipment and cause malfunctions.
3. Do not install or use the unit in the following locations:
– Locations where it may get wet from rain or water splash (including under the
eaves, etc.)
– Locations where a chemical agent is used such as a swimming pool
– Locations subject to moisture or oil smoke such as a kitchen
– Locations that have a specific environment that is subject to an inflammable
atmosphere or solvents
– Locations where a radiation, an X-ray, a strong radio wave or a strong magnetic
field is generated
– Locations with volcanic activity or hot springs where corrosive gas is produced,
locations where it may be damaged by briny air such as seashores
– Locations where the temperature is not within the specified range (see
– Locations subject to vibrations, such as on vehicles, marine vessels, or above
product lines (This product is not designed for on-vehicle use.)
– Locations subject to moisture or dust
– Locations subject to condensation as the result of severe changes in temperature
Operating Instructions
17
1 Preface
