EMS i-MO 200-S Series Hardware Installation Guide
Version
2.0
ELECTRONIC MEDIA SERVICES LIMITED
PASSFIELD BUSINESS CENTRE, LYNCHBOROUGH ROAD, LIPHOOK, HAMPSHIRE, GU30 7SB, UK
Tel:
01428 751655 |
Fax:
01428 751654 |
E-mail:
Page
9
of
20
Step 3
- Select the cable from
Modem
Aerial connector A
as shown in image
9
above. Gently undo the
black tape covering the connector.
Step 4
- Connect the end of
Modem
Aerial connector A
cable to
Modem A.
The cable ends 'click' onto the
small fittings on the modems which are labeled
'MAIN'
as shown above in images
10
and
11
.
Step 5
- If required, select the cable from the
Modem
Aerial connector B
as shown above in image
12
. This
cable is routed under the modem board to keep it clear of the case when it is re-assembled. Please leave it
in this position. Gently undo the black tape covering the connector.
Step 6
- Connect the end of
Modem
Aerial connector B
to
Modem B.
The cable ends 'click' onto the small
fittings on the modems which are labeled
'MAIN'
as shown above in image
12
.
3) How to install SIM cards (optional if not already fitted)
If SIM cards have been supplied to you with the i-MO unit, then they will already be installed. If you need to
insert or replace SIM cards then these need to be installed in the SIM card slots inside the appliance as
illustrated below.
Step 1
-
SIM A
belongs to
Modem A
and
SIM B
belongs to
Modem B
. Hold the SIM card with the cut off
corner located top left and contacts facing down, as shown below in images
1
and
2
.
Step 2
- Gently insert SIM card as shown in image
3
above. It will click into position when fully inserted - see
image
4
above. To remove SIM card, push slightly against the spring and it will click and eject slightly.
Repeat for SIM card B if required - see image
6
above.
