i-CAT FLX, Руководство по установке

Страница: 22 / 106

1-14
i-CAT FLX Installation Manual
032-0330-EN Rev K
Level Gantry
To achieve optimal performance, it is imperative that the gantry be properly leveled.
1. Scanner must be leveled from side-to-side and front-to-back.
Level Side-to-Side
Level Front-to-Back
2.
2
To level Overhead Gear, adjust the front gantry feet
from the top, using a 1/4” nut driver. Have a second
person tilt the scanner enough to minimize the load
on the feet while turning.
If the scanner does not have top access holes, tilt
scanner and adjust the feet from underneath by
rotating the large base of each foot.
CAUTION CAUTION
Never use the gate for tilting or moving the scanner, as this may cause permanent damage to the
scanner.
3.
3
1/2” Wrench
Adjust the rear gantry feet using the 1/2” open-
ended wrench.
NOTE: Ensure levelness of overhead gear is
measured front-to-back and side-to-side.