I-Cane Mobilo 2.1, Руководство пользователя

Страница: 9 / 21

9
2. Preparing your I-Cane Mobilo® for use
2.1 Take the I-Cane Mobilo® out of the package.
2.2 You must first charge the I-Cane Mobilo® . You can do this by connecting
the I-Cane Mobilo® to the power supply using the supplied magnetic USB
charge cord. Charge the I-Cane Mobilo® before you start using the
Mobilo®. During charging the red LED lights up, when the battery is full
the blue LED lights up. If the battery is empty, it will take approximately 3
to 4 hours before it is full again.
2.3 A full battery lasts, depending on the extent of use, about one day.
2.4 Expand the cane segments of the folding cane. The cane length is
specially adapted to the user . Each segment has lugs and recesses. Make
sure that the lugs of the connecting pipes fit into the recesses in the
other part. As a result, the segments are mutually fixed in the same
position. Slide the folding cane into the handle, also pay attention to the
correct position of the lug and recess. The coupling of the folding cane
with the handle is magnetic.
2.5 The Comfy Wheel® is attached to the lower segment with an elastic
hook. If necessary, adjust the wheel by holding the cane part and then
turning the wheel holder that rolls the wheel in the running direction.
2.6 The angle the Comfy Wheel® attached to the cane has an influence on
the working of obstacle warning. The greater the angle, the more the
sensor detects forward. The smaller the angle, the more the sensor
detects in height. The optimum functioning of the sensor (observation
forwards and upwards) is at an angle of 45 degrees. I-Cane has adjusted
the length of the folding cane to this. Familiarize yourself with the
operation and range of the sensor and the actions of the tactile arrow.
See also Chapter Obstacle Avoidance (3).
2.7 The I-Cane Mobilo® is switched on and off with the left push button
behind the tactile arrow . Switch on the Mobilo by pressing this button
for a full second. The LED with white light turns on. The activation is
confirmed a little later by sound signals and movements of the tactile
arrow. To turn the Mobilo off, push the button for about 5 seconds. With
successful switching off, the white LED light goes out. Do not switch the
Mobilo off and on again in quick succession, the system may then not be
sufficiently closed and will therefore not switch on.
2.8 After switching on, always check whether the sensor is in action by
moving a hand at least 5 cm above the sensor or by turning the sensor
for example towards a wall. An audio signal sounds and the arrow arrow
tilts.