I-CAN 3820T, Руководство пользователя

Страница: 23 / 26

USER GUIDE
3820T
23
Installation issues
• If you are using a directional antenna, make sure
it is pointing towards a digital TV transmitter and
positioned correctly.
• We recommend you use a standard outdoor antenna,
which normally works better than an indoor one.
• Check that the antenna cable is connected correctly.
• If these steps do not resolve the problem, you should
call your vendor.
- You cannot find
terrestrial channels.
Symptom Solution
Audio and video issues
• Your receiver has lost some of its software settings.
Switch your receiver off and then back on after a few
seconds. If the problem persists, contact your vendor.
• The signal is too weak or is defective, which could
be due to bad weather conditions. Try adjusting the
position of your antenna, or wait for the signal to be
re-established.
- The picture on your TV
screen changes color.
This may happen after
a power cut, or after
your receiver has been
disconnected from the
power source.
- Blocks appearing in the
picture on the screen.
Symptom Solution
• Make sure your TV is set to receive the signal from the
appropriate input.
• Your receiver may be in standby mode (if the LED on
the front panel is red). Press the button to turn your
receiver back to operation mode.
• Alternatively some of the connections may have
worked loose. Check that all the connections are made
properly. Then turn the receiver off and after a few
seconds turn it on again. Change the resolution by
pressing .
• The Display Format in the Options menu has not
been set to match your TV. Try a different setting (see
page 17).
• Check whether your receiver is in Mute mode. If it
is, use your receiver’s remote control and press the
volume up button.
• Check whether the volume on your receiver or TV
is sufficiently high. Press the volume buttons on the
remote control of your receiver or of your TV set.
• Check that the receiver is properly connected to your
TV or your sound system, and check that your sound
system is switched on.. Some connections may have
worked loose.
• Make sure that the program you are watching is
broadcast in surround mode, indicated by the
icon.
• Check your SPDIF audio cable is well connected
between you receiver and the Home Cinema central
unit, and check that your sound system is switched on.
• Check in the System Settings that you have selected
the surround sound audio option.
- Your TV is blank or ‘snow’
appears on the screen.
- The picture appears ‘squashed’
or cut off.
- There is no sound.
- There is not surround sound