9
ELECTRONIC AND
ELECTRICAL REPAIR
The following section will describe repair procedures and
trouble shooting hints for the game electronics.
Please read the section “Operational Background” in the
beginning of Maintenance and Trouble Shooting to get a
good understanding of the game’s basic operating pa-
rameters.
WARNING: EXERCISE CAUTION WHENEVER WORK-
ING WITH ELECTRONICS, THEY CAN BE VERY SUS-
CEPTIBLE TO DAMAGE FROM SHORT CIRCUITING,
OR PHYSICAL ABUSE. ALWAYS UNPLUG THE GAME
WHEN WORKING ON HIGH VOLTAGE AREAS OF THE
GAME, SUCH AS THE TRANSFORMER.
USE EXTREME CAUTION WHEN USING VOLTME-
TERS TO DO CIRCUIT CHECKS IF THE GAME POWER
HAS BEEN LEFT ON.
ALWAYS REMOVE THE BATTERY BACK-UP POWER
WHEN WORKING ON THE GAME. THIS IS NECES-
SARY AS SOME CIRCUITS ARE CONSTANTLY UN-
DER POWER FROM THE BATTERY.
WHEN USING A VOLTMETER, BE SURE IS SET TO
THE CORRECT VOLTAGE OR RESISTANCE RANGE
BEFORE USING. THIS CAN PREVENT POSSIBLE
DAMAGE TO THE PC BOARD OR MISDIAGNOSIS.
ALWAYS REMOVE POWER TO THE GAME WHEN
PLUGGING OR UNPLUGGING PC BOARDS.
IT IS NECESSARY TO USE ICE REPLACEMENT
PARTS TO CONTINUE WARRANTY COVERAGE. USE
OF NON-ICE APPROVED PARTS WILL NOT ONLY
VOID YOUR WARRANTY, BUT COULD CAUSE SERI-
OUS HARM TO THE GAME, OR CAUSE SERIOUS
BODILY INJURY.
IF YOU HAVE ANY QUESTIONS REGARDING REPAIR
AFTER READING THIS SECTION, CALL OUR SERVICE
DEPARTMENT BEFORE PROCEEDING AT:
I.C.E. SERVICE DEPARTMENT
716-759-0360
NORMAL BUSINESS HOURS ARE:
MONDAY – FRIDAY, 9:00 AM TO 6:00 PM EST
FUSES
Fuses are the first items that should be checked when the
game is inoperable or works incorrectly. There are 5
fuses in the game.
One fuse is located in the Power Mod which is located in
the lower left side in the rear of the cabinet.
To check or service the fuse, FIRST REMOVE THE
POWER CORD. FAILURE TO DO SO COULD RESULT
IN SERIOUS INJURY OR DEATH. Using a small flat
blade screwdriver, pry down the fuse block cover. Re-
move the fuse block from the power mod. Pull the fuse
from the fuse block and test the fuses. Be sure to replace
the fuses with the same type and value.
Three fuses are located on the Power Supply PC Board,
and one fuse is located on the AC Power PC Board. Us-
ing a small flat blade screwdriver, pry the fuse from the
fuse holder. Remove the fuse from the fuse holder and
test each fuse as required. the fuses. Be sure to replace
the fuses with the same type and value.
FUSE
MAINTENANCE & TROUBLESHOOTING
