Hyundai HYPS36LI, Руководство пользователя, Страница: 19 / 28

5.5.6.2. Take the following precautions to minimize kickback;
5.5.6.2.1. Before you start the unit, make sure the pole chain saw is not contacting any
object.
5.5.6.2.2. Always grip the saw pole and handle firmly with both hands when the unit is
unit is running. Place one hand on the pole and your other hand on the moulded
handle with your thumbs and fingers encircling the pole and handle. A firm grip
combined with proper positioning of the handle against your body will help you
maintain control of the saw if kickback occurs.
5.5.6.2.3. Make sure that the area in which you are cutting is free from obstructions.
5.5.6.2.4. Do not let the kickback danger zone area of the guide bar contact a log,
branch, fence, or any other obstruction that could be hit while you are operating
the pole chain saw (Fig. 13).
5.5.6.2.5. Always cut with the unit running at full speed. Fully squeeze the ON/OFF
trigger and maintain a steady cutting speed.
5.5.6.2.6. Wear non-slip gloves for maximum grip and protection.
5.5.6.2.7. Extend the pole only to the length required to reach the limb cut. Do not
extend the rear handle above waist height.
6. MAINTENANCE
6.1. Motor Cooling.
6.1.1. To avoid overheating and damage to the motor, always keep the cooling air vents clean and
free of sawdust and debris.
6.2. Chain Tension
6.2.1. Check the chain tension before using the saw when the chain is cold. The correct tension of
a cold chain is when there is no slack on the underside of the guide bar; the chain is snug, but
you can rotate it by hand without binding.
Before any cleaning / maintenance equipment, remove the battery pack and
disabling key.
Use protective gloves when handling the bar and chain.
Keep the bar encased in its sheath, except when working directly on the bar or the
chain.
Never dispose of oils or other polluting materials in unauthorized places.
For your safety and that of others;
Correct maintenance is essential to maintain the original efficiency and safety over
time.
Keep all nuts, bolts and screws tight to be sure the equipment is in safe working
condition.
Never use the machine with worn or damaged parts. Damaged parts are to be
replaced and never repaired.
Only use original Hyundai replacement parts. Parts that are not of the same quality
can seriously damage the equipment, compromise safety and invalidate the
warranty.
Page 19 Ver 2