Hyundai HY3810, Инструкция по эксплуатации

Страница: 13 / 20

the hook on the motor unit.
7. Pull up the chain and tighten the tensioning screw with a
screwdriver to tighten the chain. (A3)
8. Now you can screw the tensioner nut with the supplied key.
9. Check the chain before working. The chain must move if you drag it
by hand. If necessary, tighten or release the
chain by tightening or unscrewing the tensioning screw.
Fuel and chain oil
Mixture of fuel and oil
The recommended blend of fuel and oil is 1:40 or 2.5% of the
mixture. Example: Add 0.25 dl of oil to 1 litre of fuel
1. Place the chainsaw with the right side on the appropriate base.
2. Unscrew the fuel tank cap (9) and remove it.
3. Add mixture for two-stroke engines in the fuel tank. Be careful not to
overfill the tank.
NOTE: If you overfill the tank, immediately wipe up the spilled fuel. Wait
for any residual fuel to evaporate
before restarting the engine.
4. Attach the fuel tank cap
Chain oil
WARNING!
Only use special chain oil for chainsaws.
Do not use old spent oil.
1. Place the chainsaw with the right side on the appropriate base.
2. Unscrew the chain oil tank cap (10) and remove it.
3. Fill the chain oil in the tank. Be careful not to overfill the tank.
4. Attach the fuel tank cap
5. Wipe off spilled oil if necessary.
Engine ignition
WARNING!
The chainsaw must be fully assembled before starting the
device. Check fuel and chain oil level.
1. For a cold start, press the fuel pump approximately 3x, or until the