Hyundai HY2163, Руководство пользователя, Страница: 8 / 12

Page 8
5.
OPERATION, CONTROLS & INSTRUCTIONS
You must turn off saw and isolate from the mains before carrying out any
maintenance work on this tool.
5.1. Replacing the saw blade.
5.1.1. Engage the blade lock button (13) and unscrew the
blade clamping screw (14) by turning counter clockwise
using the spanner (15) supplied with the tool.
5.1.2. Retract the lower blade guard (2) using the lever (1)
and replace the blade (6). Reinstall the washer (16) in the
correct position.
5.1.3. Check the direction of rotation of the blade.
5.1.4. Thread on the blade clamping screw (17) by hand to
hold the washer in position. Turn clockwise.
5.1.5. Press the blade lock button (13) while turning the
spindle until the blade stops rotating.
5.1.6. Tighten the blade clamping screw firmly using the spanner (15).
5.2. Mounting and adjusting the parallel fence.
5.2.1. The parallel fence (9) is used for cutting parallel to the
edge of the work piece.
5.3. Mounting.
5.3.1. Slacken the locking screw (18) as to allow the parallel
fence to pass.
5.3.2. Insert the parallel fence (9) in the saw shoe (3) as
shown.
5.3.3. Tighten the locking screw (18.
5.4. Adjusting.
5.4.1. Slacken the locking screw (18) and set the parallel fence (9) to the desired width.
5.4.2. Tighten the locking screw (18).
5.5. Depth of cut adjustment.
5.5.1. Loosen the depth adjustment knob (5).
5.5.2. Move the shoe (3) to obtain the correct depth of cut.
5.5.3. Tighten the depth adjustment knob (5). For optimal results, allow the saw blade to protrude
from the work piece by about 3 mm.