Hyundai H-VCRQ80, Инструкция по эксплуатации

Страница: 7 / 28

7
.
automatically recharged. For this, the charging station must be connected to the
mains.

If the device fails to locate the charging station because e.g. the room is too large
and it comes to a stop, you should “give it helping hand”. Use the directional buttons
on the remote control to steer the device towards the charging station or place it
directly on the charging station.While the device is vacuuming, leave the charging
station connected to the mains so that it can automatically dock and recharge for
the next cleaning cycle.
Use

ATTENTION!

The device is not suitable for plush/deep-pile carpets.

Clear up all items lying around the room that could catch in the brushes or nozzle or
which could obstruct the device while cleaning. Be particularly sure to not leave
anyplastic bags on the fl oor.

Make sure that the device is not able to come into contact with cables, cords or
tassels, e.g. of curtains, table cloths or carpets. If necessary, fold the edges of
carpets with tassels under the carpet.

Remove all items that could be knocked over (e.g. vases, small lamps, decorative
items).

There should be at least 40 cm of distance between two objects (e.g. wall and shelf)
in order for the device to pass through.

The device could get stuck under pieces of furniture if it does not have the necessary
clearance. Block the path e.g. with fl ower pots that are heavy enough to prevent
being knocked off.
Operating the device/manual start

Switch the device on by pushing the start/pause switch on the device. The
start/pause switch will illuminate in red - blue - red.

Push the desired function button on the remote control (see chapter “Functions”). A
signal tone will sound, the start/pause switch will illuminate in blue. The robotic
vacuum cleaner will then start cleaning in the selected vacuuming mode.

Push the button to stop the robotic vacuum cleaner. A signal tone will sound, the
start/pause switch will illuminate in red again. The device will stop vacuuming and
automatically switch to standby mode.
Remote control

To use the remote control, you must fi rst activate the device via start/pause switch
on the device.

Start/Pause – Push the button in the middle to start the device or to pause
the device during the vacuuming process.

Directional buttons – You can use the directional buttons to steer the device
manually.

Automatic charging – Push this button to tell the device to return to the
charging station to recharge.