Hyundai H-VCRQ80, Инструкция по эксплуатации

Страница: 10 / 28

10.

Emptying the dust bin and cleaning the dust fi lter

For proper operation of the device, you should empty the dust bin and clean the fi
lters after every use.

You can knock out the fi lters and/or use the enclosed cleaning brush to brush them
out.

You can rinse the dust bin out with water.

Depress the release button on the device to let the cover fl ip up.

Pull the dust bin out on the handle.

Open the dust bin by folding the catch forward and pushing it up.

Empty the dust bin into a waste bin.

You should also clean the HEPA and dust fi lter after every use.

They are located on the front side of the dust bin.

Loosen the catch on the HEPA fi lter and pull it off. The dust fi lter is located behind
it.

Empty out any coarse dirt over a waste bin.

Insert both fi lters again. When inserting the fi lters, make sure that they are
properly secured!

If necessary, clean the dust bin with clean, warm water. Then let it dry completely
before putting it back in the device.When putting it back in the device, make sure
that the dust bin is properly seated in the dust bin compartment and that the handle
is folded down.

Close the cover. It must audibly lock into place.
Cleaning the roller brush, rubber strip and nozzles

Over time, hair, threads or other dirt and debris may collect on the roller brush.

To remove them, take the roller brush out of the device.

If the roller brush is worn out, it must be replaced. A spare roller brush is included in
the product contents.

Remove any coarse dirt from the bottom side of the device.

Place the device upside down on the ground or a table.

Release the cover with the rubber strip by pushing the two catches together and
folding the cover up.

Carefully take the roller brush out of the compartment.

Use the enclosed cleaning brush or a cloth to clean the cover with the rubber strip,
the roller brush, the compartment and nozzles.

Then put the brush back in the holder and the compartment. Make sure that the side
of the brush with the square is inserted in the corresponding recess in the
compartment.

Place the cover with the rubber strip back on the compartment and push it into
place. The cover must audibly lock into place.
Replacing the side brushes

If the side brushes are worn, they must be replaced. Two spare side brushes are
contained in the product contents.

Remove any coarse dirt from the bottom side of the device.

Place the device upside down on the ground or a table.

Use a star-headed screwdriver to loosen the screws on the side brushes.

Pull the side brushes off of the axles.

If necessary, clean the brush compartments.

Place the new side brushes on the axles and tighten the screws.