IM2021
15
9. CLEANING AND MAINTENANCE OF THE UNIT
The external body of the device must be regularly cleaned from dust and dirt, because this affects the
efficiency of its work.
Before cleaning, turn off the device and unplug it from the network, let it cool, then wipe its body with a soft,
slightly damp cloth. Then wipe it dry and allow the device to dry completely. It is not recommended to use
detergents, including detergents with abrasive compounds to clean the body of the device. Do not damage
the appliance with sharp objects, because scratches on paint can cause rust.
The rear side of the convector must also be periodically cleaned from dust and dirt. To do this, disconnect
the device from the brackets, and after cleaning, put it back on the brackets.
Cleaning should be carried out periodically to maintain the technical condition of the convector and preserve
its appearance for many years.
NOTE:
A change in the color of enamel on the front side is not a defect, but is a consequence of operation of the
device in a room with a big amount of dust particles and other contaminants in the air.
10. TROUBLE SHOOTING
Possible malfunctions and solutions for them are indicated in table
2. If it is impossible to fix these
malfunctions with these methods, contact the authorized service center.
Table 2
Malfunction
Possible cause
Solution
The device is connected
to the mains, operating mode is
set to heating but device
doesn’t work.
No power
Check whether the power
supply is disconnected from
the device and, if necessary,
connect device to power supply
Temperature limiter parted
electrical circuit and shut off
the heating elements
Ensure that the air inlet or
outlet grille is not blocked by
foreign objects and wait for
turning on of the temperature
limiter, after the body of
the device cools down.
Malfunction in circuit breaker
Change the circuit breaker
Defective power relay
Contact an authorized service
center
Defective thermostat
Defective heating element
Faulty temperature limiter
Power cord is broken
Contact an authorized service
center to fix it
Heating is not good enough
Low voltage in power network
Check power network
Low heating temperature is set on
thermostat
Set the temperature higher on
thermostat
Defective heating element
Contact an authorized service
center
11. STORAGE
Make sure that the appliance body and its heating element have cooled down before the appliance is
dismantled and packed in its packaging for long
-
term storage.
Complete all requirements of chapter CLEAN AND CARE.
Reel on the power cord.
When the device is not in use for a long time, store it in a cool, dry place in the original cardboard box.
