IM2021
13
1.
Open the packaging and carefully remove the appliance and wall
-
mounting kit from it.
2.
Remove any foam seals on the edges of the device and release it from plastic bag.
3.
According to Fig. 2 and Fig. 3 choose the location for the installation of the device in compliance with
the minimal distances from other objects and floor.
4.
Mark the height at which you want to install the convector and put visible marks on the wall.
5.
Drill holes in the wall of the required diameter according to the marks, insert the dowels*, and tighten
the screws*.
6.
Attach the mounting brackets to the convector body by inserting them into the holes in the back panel,
and turn them counterclockwise by 90°, then fasten with screws. Also screw the rubber stop to the
bottom center of the convector with a screw (see fig. 4).
7.
Mount the convector on the wall, matching the installed mounting screws in the wall with the holes of
the brackets installed on the device.
8.
Check that the installation is secure.
*Not included in the delivery set
Fig. 4
Connecting feet to the convector
Unplug the device before connecting the wheels
1.
Remove two support feet from the packaging of the convector.
2.
Turn the device upside down.
3.
Attach the support feet to the bottom of the device connecting them with the holes on the device. Attach
the feet carefully.
4.
Use the fixing screws
to tighten the feet to the convector. You may need to make some physical effort
for fastening to be secure.
5.
Double check the fastening. Turn the appliance over to correct position and set it on a flat, horizontal
surface strictly upright.
Electric convector is ready to work!
