Hyundai H-HG1-42-UI578, Инструкция по эксплуатации

Страница: 7 / 54

7.
Gas ceramic heater
EN
3. DISPOSAL
Detailed information on the recycling can be obtained from representative of the local authority.
Service life of the device speciied in the warranty card.
4. ASSEMBLY AND INSTALLATION
1. Carefully remove the heater from the package.
2. Carefully install the enclosed gas hose not twisting or breaking it. For that, screw one end of
the hose onto the gas valve connector, while the other end onto the connector of the enclosed gas
pressure controller (reducer). Secure the hose ends on the connectors with jubilee clips.
3. Install a paronite/rubber spacer inside the cap nut checking its integrity beforehand and then
carefully screw the nut on the outlet of an already prepared gas cylinder having appropriate
capacity (a gas cylinder is not included in the delivery set and purchased separately). Twisting of
the hose is strongly not allowed.
4. Slowly turning the gas pressure controller (cylinder check valve), make sure that no gas leaks
are present. For that:
• Lubricate all joints with soapy water. Gas leaks cause formation of bubbles in permeable places.
• NEVER USE MATCHES OR LIGHTERS for gas leak checks.
If you ind a gas leak, shut gas and contact your dealer or manufacturer’s service center.
or mental capabilities and having insuicient experience/knowledge, if they are not supervised and
instructed on use of the device by a person responsible for their safety. It is necessary to watch that
children do not play with the heater.
NOTE:
To improve products quality, design and technical characteristics of
the convector, as well as its scope of delivery can be revised without
advance notice.
5. Carry the heater to the supposed place of operation observing the rules and precautions de-
scribed in Section 2 of this Instruction Manual.
6. The appliance is ready for work.