Hyundai Dynamic auto 350M, Руководство по эксплуатации

Страница: 16 / 43

VER 2. 0
- 15 -
3-4-1. Weld Output Connections
To obtain full rated output from this unit, it is necessary to select, prepare, and install proper weld
cables. Failure to comply in any of these areas may result in unsatisfactory welding performance.
This value shall relate to the minimum fitting range for welding cables according to table1
Minimum range of size
(mm
2
)
Rated current in A
(60% duty cycle)
Rated current in A
(100% duty cycle)
up to 10 101 100
10 to 16 139 135
16 to 25 190 180
25 to 35 243 225
35 to 50 316 285
50 to 70 403 355
70 to 95 498 430
95 to 120 587 500
120 to 150 689 580
150 to 185 797 665
Table 1 - Relation between size range and rated current
1. The Current is rated for 60% and 100% duty cycle
2. Welding cables, the coverings of which are not capable of withstanding a
conductor temperature of 85
℃
, will be damaged if the coupling devices
are used at the rating given above at an ambient air temperature of
40 ℃ .
A. WELD Cable Selection
Use the following guidelines to select weld cables:
1. Use the shortest possible cables, and place cables close together.
Excessive cable lengths may reduce or cause unit overload due to added resistance.
2. Use weld cable with an insulation voltage rating equal to or greater than the maximum open-circuit
voltage (OCV) of the welding power source.
3. Select welding cable size according to maximum weld output and total length of connecting cables
in weld circuit. For example, if a 7.5mm electrode holder or torch cable is used with a 7.5m work
able
4. Do not use damaged or frayed cables.