FEATURES OF YOUR HYUNDAI
1- 52
B922B02F-AAT
1. POWER ON-OFF/VOLUME/
BALANCE CONTROL KNOB
The radio unit may be operated when the igni-
tion key is in the "ACC" or "ON" position. Press
the button to switch the power on. The LCD
shows the radio frequency in the radio mode or
the CD track indicator in the CD mode. To
switch the power off, press the button again.
VOLUME Control
Rotate the knob clockwise to increase the vol-
ume and turn the knob counterclockwise to
reduce the volume.
BALANCE Control
Pull and turn the control knob clockwise to
emphasize right speaker sound. (Left speaker
sound will be attenuated) When the control
knob is turned counterclockwise, left speaker
sound will be emphasized. (Right speaker sound
will be attenuated)
2. FAD (Fader Control) Knob
This knob is located behind the volume control
knob. Turn the control knob clockwise to em-
phasize front speaker sound. (Rear speaker
sound will be attenuated) When the control
knob is turned counterclockwise, rear speaker
sound will be emphasized. (Front speaker sound
will be attenuated)
3. BASS/TREBLE Control Knob
BASS Control Knob
Press to pop the knob out and turn to the left or
right for the desired bass tone.
TREBLE Control Knob
Further pull the popped-up knob. Turn to the left
or right for the desired treble tone.
4. BAND Selector
Pressing the " " button changes the AM,
FM1 and FM2 bands. The mode selected is
displayed on LCD.
5. TUNE (Manual) Select Button
Press the (+) side or (-) side to increase or to
decrease the frequency. With the button held
down for 1 second or more, the stop signal
(broadcasting radio wave) is ignored and chan-
nel selection continues.
SEEK Operation (Automatic Channel
Selection)
Press the TUNE select button 1 second or
more, and releasing will automatically tune the
next available station.
When the (+) side is pressed longer than 1
second, releasing will automatically tune the
next higher frequency and when the (-) side is
pressed longer than 1 second, releasing will
automatically tune the next lower frequency.
6. PRESET STATION SELECT Button
Six (6) stations for AM, FM and FM2 respec-
tively can be preset in the electronic memory
circuit on this unit.
HOW TO PRESET STATIONS
Six AM and twelve FM stations may be pro-
grammed into the memory of the radio. Then,
by simply pressing the band select button and/
or one of the six station select buttons, you may
recall any of these stations instantly. To pro-
gram the stations, follow these steps:
o Press band selector to set the band for AM,
FM, and FM2.
o Select the desired station to be stored by
seek, scan or manual tuning.
o Determine the preset station select button
you wish to use to access that station.
o Press the station select button for more than
two seconds. A select button indicator will
show in the display indicating which select
button you have depressed. The frequency
display will flash after it has been stored into
the memory. You should then release the
button, and proceed to program the next
desired station. A total of 18 stations can be
programmed by selecting one AM and two
FM stations per button.
o When completed, any preset station may be
recalled by selecting AM, FM or FM2 band
and the appropriate station button.
Содержание 2001 Tiburon
Страница 1: ...D R I V I N G IS B E L I E V I N G 2001 ...
