Hyundai 2000 Accent, Руководство пользователя

Страница: 25 / 136

FEATURES OF YOUR HYUNDAI
Three child restraint hook holder nuts are lo-
cated on the back panel.
If you want to install a child restraint system
hook holder, remove one of the 3 anchorage
trim plugs from the back panel, then install the
hook holder for your child restraint system with
the bolt and spacer and torque to 1.7-2.6 kgf .m
(12.3-18.8 Ib.ft, 16.7-25.5 N.m).
B230G01A-GAT
Installation on Outboard Rear Seats
On outboard rear seats
directions to be sure the child restraint system
is securely installed.
If you need to tighten the belt, pull more web-
bing toward the retractor. When you unbuckle
the seat belt and allow it to retract, the retractor
will automatteally revert back to its normal seated
passenger emergency locking usage condition.
NOTE:
o Before installlng the child restraint sys-
tem, read the instructlons supplied by
the child restraint system manufacturer.
o If the seat belt does not operate as de-
scrlbed, have the system checked Imme-
diately by your authorized Hyundai dealer.
WARNING:
Do not Install any child restraint system In
the front passenger seat. Should an acci-
dent occur and cause the passenger slde
alrbag to deploy, It could severely injure or
kill an Infant or child seated In an Infant or
child seat. Therefore, only use a child re-
straint system in the rear seat of your ve-
hlcle.
B230H01A-QAT
Child Seat Restraint Suitability For Seat Po-
sition
Use child safety seats that have been officially
approved and are appropriate for your children.
Child safety seats are classified into the follow-
ing four groups according to ECE-R-16.
To install a child restraint system in the out-
board rear seats, extend the shoulder/lap belt
from its retractor. Install the child restraint sys-
tem, buckle the seat belt and allow the seat belt
to take up any slack. Make sure that the lap
portion of the belt is tight around the child
restraint system and the shoulder portion of the
belt is positioned so that it cannot interfere with
the child's head or neck. After installation of the
child restraint system, try to move it in all
Group 0 : Up to 10 kg (0 - 9 months)
Group 0+ : Up to 13 kg (0 - 2 years)
Group 1: 9kg to 18kg (9 months ~ 4 years)
Group II & III: 15kg to 36kg (4 ~ 12 years)
A child safety seat that has passed tests sub-
ject to ECE-R-16 is inscribed with an identiflca-
tion mark: ECE-R-16 (Capital E is circled and
Inspection numbers).
U : Suitable for "universal" category restraints
approved for use in this mass group
UF : Suitable for forward-facing "universal" cat-
egory restraints approved for use in this
mass group
X : Seat position not suitable for children in
this mass group