Hyundai power products HYTD300, Инструкция по эксплуатации, Страница: 35 / 48

35
Maintenance & Care
You may need to loosen the belt guide
bracket and slide back before removing
belt.
!
Lubrication
General Lubrication
Lightly lubricate all moving parts of the
machine at the end of the season or every 25
operating hours.
Gearbox Lubrication
The gearbox is pre-lubricated and sealed at
the factory. Unless there is evidence on the
gearbox, no additional lubricate should be
required until 50 hours of use.
After first 50 hours use, change all the gear oil.
Capacity is 1.5L.
For future use, check the oil level after every
50 hours of use. If you remove the oil level
plug and no oil flows out, please add oil and
then screw the oil level plug.
Gear oil GL-5 or GL-6, SAE80W-90 is
recommended. Do not use synthetic oil.
When replacing gear oil, the engine must be
stopped and still warm. Unscrew the filter cap
and the drain plug. When oil is drained,
replace the draining plug, fill up with fresh oil,
and then replace the filter cap.
Tightening Tracks
With use, tracks tend to loosen. When
operating with loose tracks, they tend to slip
over the driving wheel causing it to jump its
housing, thus damaging wear to the housing.
To check track tightness, proceed as follows.
STEP 1
Set the machine on a flat surface with
compact ground, or on asphalt or pavement.
STEP 2
Lift the machine and set it on blocks or
supported rated for the weight of the machine
so that the tracks are approximately 4” off the
ground.
STEP 3
Measure the track midline vs. the
horizontal line. The reading must not be more
than 10cm~15cm.
If the distance is greater, proceed as follows.
STEP 1
Use the tipping handle to tip the hopper and
set it on the blocks or supports rated for the
weight of the box.