www.hyundaipowerproducts.co.uk
01646 687 880
Starting / Stopping
NOTE -
This machine is shipped without fuel and oil and MUST be filled before use. Failure to
do so may cause damage to the engine that will not be covered by warranty.
34
Cold Start
Pump the primer bulb under the carburetor 6 times.
1
2
3
Slide the on/off switch back to (I).
Pull the red choke control out.
4
With your left hand holding down the engine, firmly pull the start cord with your right hand.
Repeat until the engine starts.
CAUTION:
Pull cord slightly away from the engine to avoid catching the Choke knob.
Leave for a few seconds and then press down the throttle lock out lever. You will then be
able to pull up the throttle trigger. This will release the choke control and accelerate the
speed of the engine.
5
Warm Start
Slide the On/Off switch back towards the engine. Place left hand on top of engine
(Caution : engine may be hot). Pull the starter cord until engine starts.
See image 4.
1
Stopping
Release the throttle. Slide the On/Off Switch away from engine
1
CAUTION -
The engine and exhaust will remain hot for a while after use. Ensure the engine
and exhaust has cooled before carrying out any maintenance, refuelling or storage.
(the appliance has been turned off for less than 15-20 minutes)
