Switch-dim
2.1 Functions for driver only (without sensor head)
Synchronization
push and hold to dim
On/off control: short push (<0.4s) on the switch.
Note: Short push should be at least 0.12s, and the time interval between two pushes should be also longer than 0.12s.
Stepless dimming: long push (>0.9s) on the switch.
For fine tuning of light level: with every alternate long push, the light level goes to the opposite direction.
Built-in permanent memory: light returns to the previous dimming level when switched off and on again,
even after power failure.
Up to 64 drivers can be connected to the same switch, thanks to the programme. This means there is no need for any additional synchrony wire in
large installation, where many drivers should be controlled by one switch.
Please follow the step below to achieve synchronization function if more than one driver is connected to the same push button:
Do a long push for more than 15s, then the system is synchronized and all lights in the group dim down to 50%.
Switch-Dim Wiring Diagram
DALI + Switch-Dim Wiring Diagram
1-10V Wiring Diagram
Warning: Please make sure the correct current is selected before starting the driver!
SECTION 2 FUNCTION
SECTION 1 INSTALLATION AND WIRING
L
N
Switch-Dim
DALI
1-10V +
-
+
-
LED
DALI
L
N
Switch-Dim
DALI
1-10V +
-
+
-
LED
DALI
L
N
Switch-Dim
L
N
Switch-Dim
DALI
1-10V +
-
+
-
LED
DALI
L
N
Switch-Dim
DALI
1-10V +
-
+
-
LED
DALI
L
N
Switch-Dim
DALI
1-10V +
-
+
-
LED
DALI
L
N
Switch-Dim
DALI
1-10V +
-
+
-
LED
DALI
L
N
Switch-Dim
L
N
Note:1. "DALI" is prior to both "Switch-Dim" and "1-10V".
2. "Switch-Dim" is prior to "1-10V". To shift dimming from "Switch-Dim" to "1-10V", the end-user should short-circuit "1-10V" first for at least 3S.
