Hytera X1e, Руководство пользователя

Страница: 8 / 18

5
Please refer to the corresponding Feature Book for
operation description on how to make and receive
calls on the analog channel with signaling.
Emergency Call
In case of emergency, you can use this feature to ask
for help from your companion or the control center.
The Emergency Call has the highest priority which
can terminate the ongoing calls with lower priorities
on the current channel. You can make an emergency
call even when your radio is transmitting or receiving.
This feature needs to be configured and enabled
by your dealer. Please refer to the corresponding
Feature Book for details.
Troubleshooting
Phenomena Analysis Solution
The radio fails to
power on.
The battery may be improperly
installed.
Remove the battery and then reattach it.
The battery power may be used up. Recharge or replace the battery.
The battery may be poorly connected
due to dirtied or damaged battery
contacts. Clean the battery contacts. If the problem cannot
be solved, contact your dealer or authorized
service center for inspection and repair.
During receiving,
the voice is weak,
discontinuous or
totally inactive.
The battery voltage may be low. Recharge or replace the battery.
The volume level may be low.
Increase the volume by rotating the Volume
Control Knob.
The antenna may be loosened or
improperly installed.
Reattach the antenna after turning off the radio.
The speaker may be blocked or
damaged.
Clean the surface of the speaker. If the problem
cannot be solved, contact your dealer or
authorized service center for inspection and
repair.
You cannot
communicate with
other members.
The frequency or signaling may not
match that of other members. Set your TX/RX frequency and signaling to the
same as that of other members.
The channel type (digital/analog) may
be set inconsistently. Make sure all members are on the same digital/
analog channel.
You may be too far away from the
group members.
Move towards other members.
Irrelevant
communication or
noise is heard on
the channel.
You may be interrupted by radios using
the same frequency. Change the frequency, or adjust the squelch
level.
The radio may be set with no signaling.
Set signaling for all member radios to avoid
interference at the same frequency.