5
3. Installation
3.1
Instructions
Before you install the radio in a vehicle, be sure to read the following instructions carefully:
The radio must work with a13.6V ± 15
%
negative ground electrical system only. Ensure to check the
ground polarity and voltage of the vehicle power supply prior to installation.
Install the radio in a location where you can reach the front panel conveniently.
Check how long the screws will extend from the bottom surface of the radio before installation. Drill
the mounting hole cautiously to avoid damage to the vehicle wiring and other parts.
Install the radio with mounting bracket supplied by the Company, to avoid radio looseness in case of
accidents. The loose radio may cause bodily injury.
Connect the antenna and power cord to the radio before you install it in the bracket. And make sure
the antenna and power cord are dedicated for digital radios of the Company.
Keep sufficient clearance at the back of the radio for wiring.
Be sure to use the fuse with the same specification for DC power cord upon replacement.
If there are any other device in the vicinity of this radio, the distance between the antenna of this radio
and the antenna of such RF device shall be no less than 10 meters.
3.2
Installation Tools
Electric Drill
Cross head screwdriver
Hex socket sleeve (for 4.8 * 20mm self-tapping screws)
