HYT TC-700 Ex PLUS, Руководство по обслуживанию

Страница: 12 / 85

TC-700 EX PLUS Service Manual
11
3. Wireless Cloning Mode
Select Wireless Cloning from optional functions in programming software, and turn the radio on while
holding down PTT and SK1 keys simultaneously for 2 seconds. Then the source and target radios enter
Wireless Cloning Mode with orange LED flashing once (when both radios are turned on and stay on the
same channel), hold down PTT on the source radio to begin cloning. During cloning, the source radio
emits red LED, while the target radio emits green LED. When cloning is finished, the target radio flashes
green and sounds Beep tone, and the LED of the source radio is off. If cloning fails, the target radio
flashes red.
4. Wired Cloning Mode
Select Wired Cloning from optional functions in programming software, and turn the radio on while
holding down PTT and SK2 keys simultaneously for 2 seconds. Then the source radio enters Wired
Cloning Mode with orange LED flashing twice. Then simply turn the target radio on. Hold down PTT on
the source radio to begin cloning. During cloning, the source radio emits red LED and the target radio
emits green LED. When cloning is finished, the LEDs of both radios are off. If cloning fails, the source
radio flashes red.
5. Manual Adjust Mode
Manual adjustment is performed to adjust frequency deviation, power, sensitivity, squelch, etc.
Note:
Prior to entering this mode, select the Manual Adjust Mode from optional functions in
programming software.
The manual adjustment operations are detailed as follows:
(1) Enter Manual Adjust Mode
Turn the radio on while holding down TK and SK2 keys simultaneously for 2 seconds, and then the radio
enters Manual Adjust Mode with red LED flashing twice.
(2) Channel Number on the Channel Selector Knob
Adjust the settings on the selected channel. Channel spacing of 25KHz and low frequency F1 are
selected for each channel change.
(3) SK2 Key
Set frequency. 1 point tuning adjusts center frequency; 3 point tuning adjusts F1, F3, F5; 5 point tuning
adjusts F1-F5.