HYT TC-508, Руководство по обслуживанию

Страница: 5 / 102

TC-508 Service Manual
3
Software Specifications
 Status Indication
Operations/Functions LED Indications and Alert Tones
Wired
Clone
To enter Wired Clone Mode:
Source radio: Power on the radio while
holding down the
SK1
key for
approximately 2 seconds.
Target radio: turn it on directly.
The LED on the source radio flashes red once during
the power-on process.
Status of the source radio in Wired Clone
Mode
(After the target radio is turned on and
the cloning cable is connected, press the
PTT
key of the source radio to begin
cloning.)
The LED glows red during cloning process.
Error occurs during cloning:
a. User Clone: At the start of cloning, frequency
band and Model ID will be
checked. The LED glows orange
for 2 seconds and then goes out in
presence of any check failure. If
the
check is successfully
carried out but error occurs
during cloning, the LED will
flash orange. In this case, press
a
ny key to turn it off.
b. Factory Clone: The LED flashes orange in
presence of error. In this case,
press any key to turn it off.
The LED glows green after cloning is completed.
Status of the target radio in Wired Clone
Mode
The LED glows green during cloning.
The green LED goes out after cloning is completed.
Power On (to enter User Mode)
When the radio is turned on, a power-on alert tone
sounds and the LED flashes orange once.
When the radio is currently on a blank channel, it
sounds beep tones continuously.
Low Battery Alert
The LED flashes red, and a low-pitched tone sounds
every 20 seconds (programmable by the dealer).
Transmitting
The LED glows red during tr ansmitting.
When TOT timer expires, the radio sounds beep tone
continuously.
A TOT pre-alert tone sounds before the TOT timer
expires.
Receiving The LED glows green during receiving.
Scan
The LED flashes green once per second during
scanning.
Scan Start Alert (programmable by the dealer): one
beep will sound.
Scan End Alert (programmable by the dealer): two
continuous beeps will sound.