HYT RPU416A, Руководство пользователя

Страница: 12 / 22

12
RPU416A Software Specifications
6. Manual Adjust Mode:
Press PTT and MONI simultaneously to turn on the power
"
enter manual Adjust mode out 3
seconds later. Choose the settings by turning the channel selector knob 1-12CH, use PTT
(upward) or MONI (downward) to adjust (Notice: MIC shouldn’t be connected with external cable
while modifying),1~12CH are defined as follows:
(1) Frequency stability
(2) RF power
(3) Low power alarm
(4) Receiver sensitivity (center frequency adjust)
(5) Receiver sensitivity (low frequency adjust)
(6) Receiver sensitivity (high frequency adjust)
(7) Squelch (level 9)
(8) Squelch (level 3)
(9) CTCSS deviation (Wide)
(10) CTCSS deviation (Narrow)
(11) DQT deviation (Wide)
(12) DQT deviation (Narrow)
13~16CH are used for adjusting transmitter and receiver. Press PTT to transmit; Press MONI
to choose: Wide/Narrow, one Beep sound is Narrow, two Beep sound is Wide. 13~16CH are
defined as follows:
(13) center frequency (discrepancy of transmission and receive frequency is 0.1MHz).
(14) Lowest frequency (discrepancy of transmission and receive frequency is 0.1MHz).
(15) Highest frequency (discrepancy of transmission and receive frequency is -0.075MHz).
(16) center frequency: sends 250.3Hz CTCSS signals (discrepancy of transmission and receive
frequency is 0.1MHz).
Note:
To enter and shut off manual adjust mode by short cut the SELF. Turn on the power, and enter
settings mode, the manual function is automatically on. Press [PTT] to disable manual modify. Once
this function is disabled, this mode is not accessible, kindly suggest disable this mode after adjust.
. CPU:
CPU control M38034M4
Pin No. Port
name
I/O Function
1 TI I Input QT/DQT signal
2 BUSY I Input busy signal
3 BATT I Detect battery voltage
4 NC I NC
5 TO O Output QT/DQT
6 BEEP O Beep output
7 NC I NC
8 ENC0 I Input encode
9 ENC1 I Input encode
10 ENC2 I Input encode
11 ENC3 I Input encode
12 NC I NC
13 PTT I [PTT] input ,connect RXD
14 TXD O RS-232C output
RPU416A Software Specifications
15 RXD I RS-232C input
x16 MONI I [MONI] input
17 SELF I Program L: set up mode
18 CNVSS I Connect VSS
19 RST I Reset
20 INT0 I Power detection
21 NC I NC
22 XIN I Oscillator(7.3728MHz)