HYT Hydro Mechanical Horology watch, Инструкция по эксплуатации, Страница: 10 / 12

10
HYT SA - Route des Falaises 74
2000 Neuchâtel - Switzerland
Phone + 41 32 323 27 70
www.hytwatches.com
65
00
C
B
SETTING THE TImE
Pos C.
Zone I Zone II
10 minutes = 1 crown movement
= 1 sec of manipulation
INTRODUCTION
This function allows the time shown on your watch to be set using the crown.
IMPORTANT
• To move nanofluids within a capillary
3
should require no less caution than setting a
perpetual calendar or a minute repeater
• We highly recommend to move the fluid by 10 minutes on each crown movement
• The «speed» of the minute hand covering 10 minutes each sequence is approximately
1-2 seconds
• It is not particulary slow, as you will move the fluid for a full hour in approximately
12 seconds in total.
HOW TO USE
• Unscrew the crown and pull it out to position C
• Then turn the crown in either direction until the coloured liquid (hour display) and the
minute hand is at the time required
• Push the crown in completely against the case
• Do not forget to screw in the crown completely to ensure its water resistance.
RETROGRADE
• The automatic return of the fluid (retrograde)
4
is
allowed by the pressure of the two bellows
2
. The
speed is higher when the retrograde
4
starts at
6:00 in «Zone II» and is minimal when the liquid
approaches its starting point in «Zone I».