Hyster H40-60XT, Руководство по эксплуатации

Страница: 56 / 180

hydraulic function will be enabled and the operator can
continue to load and unload material.
Starting Procedure
DO NOT start or operate the lift truck,
including any of its functions or attach-
ments, from any place other than the des-
ignated operator's position.
WARNING
LPG is very flammable. An odor of LPG
fuel can indicate a leak in the fuel sys-
tem. DO NOT start the engine until the fuel leak is
repaired and the atmosphere is free of LPG.
NOTE: Lift trucks have a "Clear Flood Mode" programmed
into the ECU. When accelerator is depressed more than
80% during cranking, the ECU will not allow any fuel into
the engine. This allows the engine to clear any excess fuel
out of the intake manifold and cylinders.
1. If the lift truck uses LPG fuel, open fuel valve on LPG
tanks.
2. Make sure that parking brake is applied.
3. Put direction control lever for transmission in NEUTRAL
position.
4. Make sure lift truck hood is closed.
5. Turn key to the ON position. If lift truck is equipped with
a diesel engine and engine is cold, the cold start indicator
light will illuminate and the cold start circuit will be ener-
gized.
6. On lift trucks equipped with a LPG engine, turn the key
to the START position to engage the starter.
On lift trucks equipped with a diesel engine, if cold start
delay is required, the cold start indicator will be illuminated
and a countdown time of ten seconds is displayed. When
countdown reaches 0, turn the key to the
START position
to engage the starter.
For all engine types, if engine fails to start after 30 sec-
onds, the starter will shut down for 60 seconds to cool off.
A 60-second countdown timer will appear on the LCD
screen showing the time remaining before a restart attempt
can be tried. To restart engine, repeat
Step 5 and Step 6 .
Operating Procedures
54