2100 SRM 103
Tilt Cylinder Repair
Tilt Cylinders for XM and XMS Models
NOTE:
The following procedure is for these models:
S/H/E/2.00-3.00XM (S/H/E/40-65XM), J2.00-3.00XM
(J40-60XM,
J40-60XM
2
)
(A216),
J2.00-3.00XM
(J40-60Z)
(A416),
J1.60-2.00XMT
(J30-40XM)
H/S/E1.25-1.75XM, H/S/E2.00XMS (S/H/E25-35XM,
S/H/E40XMS).
NOTE:
Always use new seals and O-rings. Make sure
all parts are clean. Lubricate all parts with clean
hydraulic oil.
1.
Install the piston seal and O-ring(s) onto the pis-
ton. See Figure 2 and Figure 3. Install the piston
onto the cylinder rod. Make sure the piston seal
is not damaged. Tighten the nut on the piston
rod to the value shown in Torque Specifications.
2.
Install a new wiper and rod seal.
Install the
O-ring and backup ring onto the retainer.
3.
Install the retainer assembly onto the rod.
4.
Install the piston and rod assembly into the cylin-
der. Tighten the retainer to the value shown in
Torque Specifications.
NOTE: After assembly is complete, install the rod
end on the cylinder rod. Tighten the capscrew on the
rod end as specified in Mast section for your specific
lift truck.
1.
CYLINDER SHELL
2.
NUT
3.
PISTON
4.
O-RING
5.
SEAL RING
6.
PISTON ROD
7.
O-RING
8.
BACKUP RING
9.
SEAL RING
10. RETAINER
11. WIPER RING
Figure 2. Tilt Cylinders for S/H/E/2.00-3.20XM (S/H/E/40-65XM), J2.00-3.00XM (J40-60XM,
J40-60XM
2
) (A216), J2.00-3.20XM (J40-60Z) (A416)
3
