Troubleshooting
2100 SRM 103
Troubleshooting
PROBLEM
POSSIBLE CAUSE
PROCEDURE OR ACTION
Tilt cylinder movement is
slow or not smooth.
Air is in the hydraulic system.
Remove air from hydraulic system.
The hydraulic pump is worn or dam-
aged.
Repair or replace hydraulic pump.
Restriction in the hydraulic lines.
Repair hydraulic lines.
Seals in tilt cylinder are damaged.
Replace seals and inspect cylinder
bore for damage.
Tilt cylinders have internal damage.
Repair or replace cylinder.
Load is greater than capacity.
Reduce load.
Pressure relief valve(s) is not ad-
justed correctly or is damaged.
Repair or adjust relief valve(s).
Large leaks between spool and bore.
Replace valve section.
Spool is not fully extended or re-
tracted.
Adjust linkage to spool.
Tilt control spool is damaged.
Repair control valve.
The tilt cylinders permit the
mast to move when the Tilt
control lever is in the Neu-
tral position.
There are leaks in the hydraulic
lines.
Tighten fittings or repair leaks.
Seals in tilt cylinder are damaged.
Replace seals and inspect cylinder
bore for damage.
Tilt cylinders have internal damage.
Repair or replace cylinder.
Tilt control spool is damaged.
Repair control valve.
14
