Hyster H177, Периодическое техническое обслуживание

Страница: 75 / 80

8000 SRM 707 Wheel and Tire Replacement
STEP 4.
Put cage in position on tire. Use press to push tire
from wheel rim.
Install Wheel in Tire
NOTE: When you assemble the wheels, see Figure 46. There are several types of wheels used on these series
of lift trucks. Do not use a two-piece pneumatic wheel for solid rubber tires.
WARNING
Failure to follow these procedures will cause damage to the tire and wheel assembly and can cause
an injury.
• Clean and inspect all parts of the wheel before installing the tire.
• DO NOT use any damaged or repaired wheel parts.
• Make sure all parts of the wheel are the correct parts for that wheel assembly.
• DO NOT mix parts between different types or manufacturers of wheels.
• DO NOT mix types of tires, type of tire tread, or wheel assemblies of different manufacturers on
any one lift truck.
Do not use a steel hammer on the wheel. Use a rubber, lead, plastic, or brass hammer to put parts
together. Make sure the side ring is in the correct position. The ends of the side ring must not
touch. The clearance at the ends of the lock ring will be approximately 13 to 25 mm (0.5 to 1.0 in.)
after it is installed. If the clearance is wrong, the wrong part has been used.
CAUTION
Too much lubricant can cause the tire to slide and move around the wheel rim.
STEP 1.
Lubricate wheel rim and inner surface of tire with
tire lubricant or soap.
69