CAUTION
Make sure that the wiring is properly routed to
prevent steering problems and chafing of the har-
ness.
7.
Connect the control handle wiring harness to the main
wiring harness.
8.
Connect the brake switch connector and, if equipped,
the optional coast control.
CAUTION
Make sure the wiring harness is not wrapped
around the gas spring. Check the wiring harness
with the control handle in the full up and full down
positions. Turn the control handle fully to the left
and right to check for restrictions.
9.
With the control handle in the upright position, pull the
harness and check for binding. Position the wiring har-
ness with slack distributed evenly to allow for move-
ment when the control handle is turned in any direc-
tion.
1. SCREW
2. COVER
3. PIN
4. PIVOT SHAFT
5. SWIVEL
6. GREASE FITTING
7. NUT
8. NUT PLATE
9. BRAKE SWITCHES
10. SHIM
11. BUSHING
12. CONTROL ARM
13. PLUG
14. BALL PIVOT
15. CAPSCREW
16. WASHER
17. CLAMP
18. NUT
19. GAS SPRING
Figure 5. Control Handle (Standard Steering)
Control Handle
1600 SRM 1637
6
