NOTE:
BACK SIDE OF DISPLAY PANEL SHOWN.
1. PIN CONNECTOR
2. PINCH POINTS
3. KEY OR KEYLESS SWITCH COVER
Figure 5. Key or Keyless Switch Removal
NOTE:
KEY SWITCH SHOWN.
1. KEY SWITCH
2. DISPLAY PANEL
3. NOTCH
Figure 6. Key or Keyless Switch Installation
Electronic and Manual Hydraulic Controls
GENERAL
WARNING
Before replacing any part of the manual hydraulic
control assembly, fully lower all parts of the mast
and tilt it forward until the tips of the forks touch
the ground. This action will prevent the mast from
lowering suddenly if the control lever is acci-
dently moved.
WARNING
Discharge capacitors as directed in Discharging
the Capacitors in General section of this manual.
Disconnect the battery before doing any work on
the electrical system. Serious injury to personnel
and/or damage to lift truck components can occur
if battery is not disconnected.
WARNING
Never wear any metallic items on your fingers,
arms, or neck. Metal items can accidently make an
electrical connection and cause an injury.
CAUTION
A short circuit and damage can occur if wires are
not installed correctly. Make sure wire connectors
do not touch the other metal terminals or wire
connectors, metal brackets, or the bracket mount-
ing nuts. Make sure the wires are not pulled tight
and are not touching other parts to damage the in-
sulation.
The lift trucks covered in this service manual come
standard with manual hydraulic control levers, but
have the option of using electronic-hydraulic (E-Hy-
draulic) mini-lever controls.
Electronic and Manual Hydraulic Controls
2200 SRM 1524
6