4.
When display panel is pulled from the display
panel cover, the warning buzzer will disconnect
from the rear of the display panel. See Figure 3.
NOTE:
REAR OF DISPLAY PANEL AND DISPLAY
PANEL COVER SHOWN. SOME ELECTRICAL
COMPONENTS AND CONNECTIONS OMITTED
FOR CLARITY.
1. WARNING BUZZER
2. DISPLAY PANEL
3. DISPLAY PANEL COVER
4. PIN CONNECTOR
5. WARNING BUZZER ELECTRICAL CONNEC-
TION
Figure 3. Warning Buzzer
5.
Disconnect display wire harness from pin con-
nector on the back of the display panel. Remove
display panel from lift truck. See Figure 4.
6.
Remove key or keyless switch from display
panel by pinching in on pinch points and pull-
ing key or keyless switch from display panel.
See Figure 5.
Install
NOTE:
If switch being installed uses a key, insert
key into switch first.
This will help install the switch into the display
panel. If switch is keyless, use the knob to help in-
stall switch into display panel.
1.
Take new key or keyless switch and install into
display panel. Match the notches on the switch
with the holes on the switch cover. See Figure 5
and Figure 6. Switch will snap into place.
2.
Connect display wire harness to pin connector
on back of the display panel. See Figure 4.
3.
Connect warning buzzer to back of display
panel. See Figure 3.
4.
Insert notches on the top of display panel into
slots on the top of display panel cover. See Fig-
ure 2.
5.
Push in the bottom of display panel until notch
on the bottom slides into slot on the bottom and
display panel locks into place inside the cover.
See Figure 2.
1. PIN CONNECTOR
2. KEYSWITCH
Figure 4. Disconnecting Display Panel
2200 SRM 1524
Display Panel and Key or Keyless Switch Replacement
5