Hypro 9910-D1064, Инструкция по установке, эксплуатации, ремонту и каталог запасных частей

Страница: 8 / 24

- 8 -
The 9910-GS50GI control unit is designed for the control of pressures up to 725 psi and flows up to 48 gpm. It consists
of an adjustable pressure relief valve, a manual pressure release lever, and three individual ball valve-controlled, 1/2"
O.D., hose barb outlets.
Control Unit 9910-GS50GI
Main Bypass Outlet
(Connect directly to tank
without restrictions or
ball valves)
Installation
Operation
*Refer to the parts list on page 9 for part number references.
Pressure
Release
Lever
Inlet Port
Adapter
Outlet
Ball Valve
Pressure
Gauge
Pressure
Adjustment
Knob
Model 9910-GS50GI shown with Remote Mounting Kit No. 9910-KIT1742.
1/2" Ball
Valve Outlets
Form L-1383 (12/11, Rev. B)
Remote Mounting * (Use Kit No. 9910-KIT1742)
1. Remove the studs (Ref. 61) from the control unit body
(Ref. 62).
2. Insert the lubricated o-rings (Ref. 25) into the
groove of the relief valve body and the port
adapter (Ref. 37).
3. Install the mounting bracket (Ref. 29) in the desired
position and secure.
4. Mount the control unit and the port adapter on
opposite sides of the mounting bracket and secure
with studs (Ref. 61).
5. With a high pressure hose, connect the NPT fitting on
the control unit to the NPT fitting on the discharge
manifold of the pump.
6. Connect the bypass hose to the bypass port hose
barb elbow (Ref. 38) and run it unrestricted back to
the tank.
7. Connect the desired amount of lines to the outlet port
hose barbs (Ref. 33). Unused ports can be shut off
with the ball valve, or they can be plugged.
1. Refer to the pump operation instructions for the proper
operation of the pump.
2. The control unit can be put into full bypass mode by
lifting the pressure release lever into the up position.
3. With the pressure release lever in the down
(pressure) position, pressure can be controlled with
the adjustment knob at the end of the relief valve.
Turning it clockwise will increase the operating
pressure and turning it counterclockwise will decrease
the pressure.
4. Flow can be controlled with the ball valves on each of
the outlet ports.