HYPERVSN Wall, Руководство по эксплуатации

Страница: 14 / 53

14 © Copyright 2018 HYPERVSN. All rights reserved
5. WALL ASSEMBLY WORKFLOW
Follow the 5 steps below to assemble the Wall.
5.1 DEVICE ASSEMBLY (STEP 1)
Important.
•
If the Devices have been stored in low temperatures, leave them indoors for
at least 2 hours before use. This avoids moisture condensing on internal
components of the Devices, which otherwise may damage to the Devices.
•
Do not touch LEDs of the rays. This may damage them.
Attention. Before assembling each Device, double-check that the components seem to
be in good working order:
•
Ensure that the wireless antenna remains with its full integrity. (Do not cut the
wireless antenna off).
Picture 5. Wireless antenna
• The rays should not have any cracks or other visual damage.
•
The stator should not have any dents.
• If the Device is supplied disassembled, check that the shaft is perpendicular to the
bottom (back side) of the stator, the shaft should turn on its axis (rotate the shaft
with your fingers).
Contact your supplier if you notice any irregularities during your component check
.
WIRELESS ANTENNA