Powermax125
Service Manual 808070
175
9 – Power Supply Component Replacement
Install the end panel bracket
1.
Align the end panel bracket positioning posts
with the holes in the top of the front and rear panels. Make sure the
end panel bracket mounting tabs
are positioned on the fan side of the power supply.
2.
Push the end panel bracket straight down onto the power supply.
3.
Tighten the 2 end panel bracket mounting screws to 11.5 kg-cm (10 inch-pounds).
Figure 42
4.
Complete the following procedures:
a.
b.
Install the power supply cover
c.
Reconnect the power and gas supply.
1
2
1
2
1
Содержание Powermax 125
Страница 1: ...Powermax125 Plasma Arc Cutting System Service Manual 808070 Revision 1 English ...
Страница 3: ...Powermax125 Service Manual 808070 Revision 1 English April 2014 Hypertherm Inc Hanover NH 03755 USA ...
Страница 6: ......
Страница 56: ...56 Powermax125 Service Manual 808070 4 Hand Torch Setup ...