Hypertherm HyPerformance Plasma HPR400, Инструкция по эксплуатации

Страница: 24 / 355

Sc-8 Safety and Compliance
Safety
lASER RADIAtIoN
Exposure to the laser beam from a laser pointer can result in serious eye injury. Avoid direct eye exposure.
On products that use a laser pointer for alignment, one of the following laser radiation labels has been applied on the product near where the
laser beam exits the enclosure. The maximum output (mV), wavelength emitted (nM), and, if appropriate, pulse duration are also provided.
Additional laser safety instructions:
• Consult with an expert on local laser regulations. Laser safety
training may be required.
• Do not allow untrained persons to operate the laser. Lasers can be
dangerous in the hands of untrained users.
• Do not look into the laser aperture or beam at any time.
• Position the laser as instructed to avoid unintentional eye contact.
• Do not use the laser on reflective workpieces.
• Do not use optical tools to view or reflect the laser beam.
• Do not disassemble or remove the laser or aperture cover.
• Modifying the laser or product in any way can increase the risk of
laser radiation.
• Use of adjustments or performance of procedures other than those
specified in this manual may result in hazardous laser radiation
exposure.
• Do not operate in explosive atmospheres, such as in the presence of
flammable liquids, gases, or dust.
• Use only laser parts and accessories that are recommended or
provided by the manufacturer for your model.
• Repairs and servicing must be performed by qualified personnel.
• Do not remove or deface the laser safety label.
ADDItIoNAl SAFEty INFoRMAtIoN
1. ANSI Standard Z49.1, Safety in Welding and Cutting, American
Welding Society, 550 LeJeune Road, P.O. Box 351020,
Miami, FL 33135
2. ANSI Standard Z49.2, Fire Prevention in the Use of Cutting
and Welding Processes, American National Standards Institute,
1430 Broadway, New York, NY 10018
3. ANSI Standard Z87.1, Safe Practices for Occupation and
Educational Eye and Face Protection, American National
Standards Institute, 1430 Broadway, New York, NY 10018
4. AWS F4.1, Recommended Safe Practices for the Preparation
for Welding and Cutting of Containers and Piping That Have
Held Hazardous Substances, American Welding Society,
550 LeJeune Road, P.O. Box 351040, Miami, FL 33135
5. AWS F5.2, Recommended Safe Practices for Plasma Arc
Cutting, American Welding Society, 550 LeJeune Road,
P.O. Box 351040, Miami, FL 33135
6. CGA Pamphlet P-1, Safe Handling of Compressed Gases in
Cylinders, Compressed Gas Association, 1235 Jefferson Davis
Highway, Arlington, VA 22202
7. CSA Standard W117.2, Code for Safety in Welding and Cutting,
Canadian Standards Association Standard Sales, 178 Rexdale
Boulevard, Rexdale, Ontario M9W 1R3, Canada
8. NFPA Standard 51B, Cutting and Welding Processes, National
Fire Protection Association, 1 Batterymarch Park, Quincy, MA
02169-7471
9. NFPA Standard 70, National Electrical Code, National Fire
Protection Association, 1 Batterymarch Park, Quincy, MA
02169-7471
10. OSHA, Safety and Health Standards, 29FR 1910 U.S.
Government Printing Office, Washington, D.C. 20402
11. AWS Safety and Health Fact Sheets, American Welding Society,
550 LeJeune Road, P.O. Box 351040, Miami, FL 33135,
www. aws.org/technical/facts/