2. DEFLATING YOUR SUP
• Turn inflation valve to the “DOWN” position by pressing down with your thumb
and turning to the right until it locks and air releases.
3. FIN INSTALLATION
4. STORAGE AND CARE
• Insert alignment pins on front of fin into the corresponding location on the fin box.
• When not in use, rinse off iSUP with fresh water, dry completely and store in a cool, dry place out of direct sunlight.
DO NOT STORE WET.
Using common sense and reasonable care will greatly extend the life of this product.
5. CONSTRUCTION AND WARRANTY
• This item is manufactured of the highest quality materials available and is designed to provide hours of fun
when used in the proper conditions.
• Manufacturer’s warranty covers defects in materials and workmanship for a period of one year
• Slide front of fin to the front of the fin box.
• Push back of fin down until the locking arm is in the up position.
• Push locking arm down to lock fin into position
3
• Stand on the base of the hand pump with one foot on each side.
• Begin pumping air into your iSUP by depressing and retracting the handle on the pump.
• You will hear air flowing into you iSUP.
• Continue to pump air until the PSI gauge on the pump reads 15 PSI (1 BAR).
(*DO NOT EXCEED 18 PSI / 1.2 BAR)
• Once you have achieved the proper PSI, return the valve cover by inserting it over the
air release valve and turning the valve cover CLOCKWISE until it will not turn any more.
THIS IS THE CLOSED POSITION
HAND PUMP INFLATION INSTRUCTIONS:
AUSTRALIA: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
